200-601 | You are called at home at 3am by an unskilled…

Question: 4

You are called at home at 3am by an unskilled machine operator with a suspected network related problem; the controller LEDs are all normal but the output module’s communications LED is not on. The operator has verfied the cable is functional and correctly connected from the communication module to the switch. What is the next check that you ask the unskilled machine operator to make?

A. Log onto the switch using the console port and check that IGMP snooping is enabled
B. Open wireshark and check whether the controller is issuing a forward open instruction to the device
C. Open the diagnostic faceplate on the HMI for the control panel switch and check that the relevant ports are enabled and not in alarm
D. Open Studio 5000 and check the module status tab for the affected output module

Answer: C

200-601 | You have been tasked to design an Ethernet network…

Question: 3

You have been tasked to design an Ethernet network capable of Motion control with cycle times not to exceed 1ms. In order to create a more deterministic network, what characteristic/s should you primarily focus on?

A. Lattency and Jitter
B. Redundancy and high availability
C. Explicit and Implicit messaging
D. This cycle time is not possible on an Ethernet network
E. Gigabit port speed

Answer: A

200-601 | What are three Cisco best practices for running I/O control…

Question: 2

What are three Cisco best practices for running I/O control traffic in a wireless environment? (Choose three)

A. 3200 packets per second and 20% bandwidth for HMI and maintenance traffic.
B. 2200 packets per second and 20% bandwidth for HMI and maintenance traffic
C. I/O control traffic can be run on 2.4 or 5 GHZ channels
D. I/O control traffic should be run on 5GHZ channels only
E. Standard I/O RPIs less than 20ms are not practical for wireless media because the maximum latency and jitter become comparable or greater than the RPI
F. Standard I/O RPIs less than 10ms are not practical for wireless media because the maximum latency and jitter become comparable or greater than the RPI

Answer: B,D,F

200-601 | Which configuration enables an…

Question: 1

Which configuration enables an Industrial Ethernet switch to participate in PTP clock selection and sets the priority value that would break the tie between switches with matching default criteria to 50?

A. ptp mode boundary
ptp priority1 10
ptp priority2 50

B. ptp mode boundary
ptp priority1 50
ptp priority2 10

C. ptp mode e2etransparent
ptp priority1 50
ptp priority2 10

D. ptp mode e2etransparent
ptp priority1 10
ptp priority2 50

Answer: A

Free 200-601 Dumps PDF exam questions answers. These Q&A online braindumps are free to use for your 200-601 Dumps PDF practice test. We keep adding more questions so keep coming to get dumps.

Leave a Comment.