Category: 200-125 Sample Questions

Preparing Cisco 200-125 exam is not difficult now. You can prepare from Cisco Books or 200-125 dumps. Here we have mentioned some sample questions. You can use our free 200-125 study material notes for test preparation. Latest 200-125 exam dumps available.

200-125 Dumps

Preparing Cisco 200-125 exam is not a big deal now with our 200-125 braindumps. You can prepare from officially recommended Cisco 200-125 Books or 200-125 dumps. Here at Cisexams, we have mentioned some free 200-125 Questions Answers. You can use our free Cisco 200-125 Study Material to get an idea about the quality and validity of this resource. Our Cisco 200-125 PDF and 200-125 dumps practice tests have helped thousands of candidates from all around the world to get their desired certification. Latest 200-125 Real Exam Questions are available with 100% money back guarantee. You have nothing to lose now!!!

200-125 Sample Questions | You need to manually assign IPv6 addresses

Question : 11

You need to manually assign IPv6 addresses to the interfaces on an IPv6-enabled router. While assigning addresses, you need to ensure that the addresses participate in neighbor discovery and in stateless auto-configuration process on a physical link. Which of the following addresses can be assigned to the interfaces?

A. FEC0:0:0:1::1/64
B. FE80::260:3EFF:FE11:6770/10
C. 2001:0410:0:1:0:0:0:1/64
D. 2002:500E:2301:1:20D:BDFF:FE99:F559/64

Answer: B

200-125 Sample Questions | Two catalyst switches on a LAN are

Question : 10

Two catalyst switches on a LAN are connected to each other with redundant links and have Spanning Tree Protocol (STP) disabled. What problem could occur from this configuration?

A. It may cause broadcast storms.
B. All ports on both switches may change to a forwarding state.
C. It may cause a collision storm.
D. These switches will not forward VTP information.

Answer: A

200-125 Sample Questions | Which of the following commands is

Question: 9

Which of the following commands is used to verify the link-local, global unicast, and multicast addresses of an IPv6 router?

A. show ipv6 neighbors (only link-local addresses)
B. show ipv6 route
C. show ipv6 protocols
D. show ipv6 interface

Answer: D

200-125 | Which two correctly describe steps in the OSI data…

Question: 7

Which two correctly describe steps in the OSI data encapsulation process? (Choose two.)

A. The presentation layer translates bits into voltages for transmission across the physical link.
B. The data link layer adds physical source and destination addresses and an FCS to the segment.
C. Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
D. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
E. The transport layer divides a data stream into segments and may add reliability and flow control information.

Answer: CE

200-125 | Which condition does the err-disabled…

Question: 6

Which condition does the err-disabled status indicate on an Ethernet interface?

A. There is a duplex mismatch.
B. The device at the other end of the connection is powered off.
C. The serial interface is disabled.
D. The interface is configured with the shutdown command.
E. Port security has disabled the interface.
F. The interface is fully functioning.

Answer: E

200-125 Practice Test

200-125 | What will happen if a private IP address…

Question: 5

What will happen if a private IP address is assigned to a public interface connected to an ISP?

A. A conflict of IP addresses happens, because other public routers can use the same range.
B. Addresses in a private range will not be routed on the Internet backbone.
C. Only the ISP router will have the capability to access the public network.
D. The NAT process will be used to translate this address to a valid IP address.

Answer: B

200-125 | What are three advantages of VLAN…

Question: 4

What are three advantages of VLANs? (Choose three.)

A. They establish broadcast domains in switched networks.
B. They provide a low-latency internetworking alternative to routed networks.
C. They utilize packet filtering to enhance network security.
D. They can simplify adding, moving, or changing hosts on the network.
E. They allow access to network services based on department, not physical location.
F. They provide a method of conserving IP addresses in large networks.

Answer: A,D,E

200-125 | Which command can you….

Question: 3

Which command can you enter to determine whether serial interface 0/2/0 has been configured using HDLC encapsulation?

A. router#show platform
B. router#show interfaces Serial 0/2/0
C. router#show ip interface s0/2/0
D. router#show ip interface brief

Answer: B