300-101 Dumps - Real Exam Questions

Practice Our 300-101 Dumps Exam Questions and Pass Your Exam Easily.

300-101 Dumps

Preparing Cisco 300-101 exam is not difficult now. You can prepare from Cisco Books or 300-101 dumps. Here we have mentioned some sample questions. You can use our free 300-101 study material notes for test preparation. Latest 300-101 exam questionsavailable.

Implementing Cisco IP Routing

Exam Number 300-101 ROUTE 

Associated Certifications:
CCNP Routing and Switching CCDP

Duration: 120 minutes (45-65 questions)
Available Languages: English

Register Pearson VUE

REview type exam questions

300-101 Dumps

Which prefix is matched by the command ip prefix-list name permit ge 24 le 24?


Answer: B

Which encapsulation supports an interface that is configured for an EVN trunk?

A. 802.1Q
D. Frame Relay

Answer: A

What is the default OSPF hello interval on a Frame Relay point-to-point network?

A. 10
B. 20
C. 30
D. 40

Answer: A

What is the purpose of the autonomous-system {autonomous-system-number} command?

A. It sets the EIGRP autonomous system number in a VRF.
B. It sets the BGP autonomous system number in a VRF.
C. It sets the global EIGRP autonomous system number.
D. It sets the global BGP autonomous system number.

Answer: A


To configure the autonomous-system number for an Enhanced Interior Gateway Routing Protocol (EIGRP) routing process to run within a VPN routing and forwarding (VRF) instance, use the autonomous-system command in address-family configuration mode. To remove the autonomous-system for an EIGRP routing process from within a VPN VRF instance, use the no form of this command.

  • Autonomous-system autonomous-system-number
  • no autonomous-system autonomous-system-number

Which encapsulation supports an interface that is configured for an EVN trunk?

A. 802.1Q
D. Frame Relay

Answer: A


Restrictions for EVN:

  • An EVN trunk is allowed on any interface that supports 802.1q encapsulation, such as Fast Ethernet, Gigabit Ethernet, and port channels.
  • A single IP infrastructure can be virtualized to provide up to 32 virtual networks end-to-end.
  • If an EVN trunk is configured on an interface, you cannot configure VRF-Lite on the same interface.
  • OSPFv3 is not supported; OSPFv2 is supported.

Which statement describes what this command accomplishes when inside and outside interfaces are correctly identified for NAT?
ip nat inside source static tcp 80 8080 extendable

A. It allows host to access external websites using TCP port 8080
B. It allows external clients coming from public IP to connect to a web server at
C. It allows external clients to connect to a web server hosted on
D. It represents an incorrect NAT configuration because it uses standard TCP ports

Answer: C

An engineer has configured a router to use EUI-64, and was asked to document the IPv6 address of the router. The router has the following interface parameters:
mac address C601.420F.0007
subnet 2001:DB8:0:1::/64
Which IPv6 addresses should the engineer add to the documentation?

A. 2001:DB8:0:1:C601:42FF:FE0F:7
B. 2001:DB8:0:1:FFFF:C601:420F:7
C. 2001:DB8:0:1:FE80:C601:420F:7
D. 2001:DB8:0:1:C601:42FE:800F:7

Answer: A

Which two statements indicate a valid association mode for NTP synchronization? (Choose two.)

A. The client polls NTP servers for time.
B. The client broadcasts NTP requests.
C. The client listens to NTP broadcasts.
D. The client creates a VPN tunnel to an NTP server.
E. The client multicasts NTP requests.

Answer: AC

A network administrator executes the command clear ip route. Which two tables does this command clear and rebuild? (Choose two.)

A. IP routing
C. ARP cache
D. MAC address table
E. Cisco Express Forwarding table
F. topology table

Answer : AB

Which statement about the use of tunneling to migrate to IPv6 is true?

A. Tunneling is less secure than dual stack or translation.
B. Tunneling is more difficult to configure than dual stack or translation.
C. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.
D. Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.

Answer : C

page 1 from 2 next page »


Recent Post